Covered
- Radiators
- Heat pump
- Heating elements
- Gas valves to furnace
- Baseboard convectors
- Hydronic circulating pumps
- Gas, electrical, oil furnaces
- Thermostats (including base)
- Heat pump refrigerant recharging
Not Covered
Auxiliary space heaters, cable heat, mini-split ductless systems (including heat pump versions), humidifier/dehumidifier systems or accessories, filters (including electronic air cleaners), registers, fuel storage tanks, heat lamps, fireplaces and key valves, baseboard casings and grills, chimneys, flues and vents, underground or outside components and piping for geothermal or water source heat pumps, well pumps and well pump components for geothermal or water source heat pumps, grain, pellet, or wood heating units (even if only source of heating), electronic, computerized, pneumatic and manual system management and zone controllers and heat pump refrigerant recapture, reclaim and disposal.
Company shows examples of components "not covered" to assist your understanding of this Contract; and examples are not exhaustive.
Note
- Coverage for diagnosis, access, repair or replacement of any geothermal or water source heat pump, glycol, heated water, steam or water heater/heating combination unit is limited up to $1,500.
- If Company determines that a package unit or the condenser of a central air conditioning or heat pump split system must be replaced, Company will replace the unit with a unit that meets current federal, state or local government efficiency standards. This note also applies to central air conditioning.
Additional coverage with purchase of First Class Upgrade
- Registers, grills, filters, heat lamps.
- Company will cover fees associated with the use of cranes or other lifting equipment required to service roof-top heating units.
- Where local building permits are required prior to commencing replacement of appliances, systems or components, Company will pay up to $250 per occurrence for such local building permits. Company will not be responsible for replacement service when permits cannot be obtained.
- Company will pay costs related to refrigerant recapture, reclaim and disposal (if required) and the removal of an appliance, system or component when Company is replacing a covered appliance, system or component.
- Company will pay up to $250 to correct code violations when effecting approved repairs or replacements. Company may, at its option, pay the contract holder in lieu of performing the work.
- Company will repair or replace a system or appliance (excluding ductwork) that was improperly installed, modified or repaired, or was not properly matched in size or efficiency at any time prior to or during the term of this Contract provided the system is not undersized relative to the square footage of area being cooled or heated. In the event that a covered mismatched system or improper installation, modification or repair is in violation of a code requirement, the $250 code violation coverage applies.